|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
07-22-2023, 09:14 AM
|
#1 |
|
Senior Member
Join Date: May 2022
Location: Lakeland Florida
Posts: 380
|
Body/fender gap
I’m getting ready to install welting.
There is a 1/2” gap on both side in the area between fender and cowl as show below. There is an open hole in the cowl on both sides. The fender is not drilled for a bolt in that area. Welting will cover part of the gap, but is this correct/normal for the car? Orange photo is of another 38 cs that does not have the gap..,. Last edited by 38convsedan; 07-22-2023 at 09:57 AM. |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 05:15 PM.