|
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
![]() |
Thread Tools | Display Modes |
![]() |
#1 |
Senior Member
Join Date: May 2010
Location: Vernon, BC
Posts: 226
|
![]()
When I tighten up the lower cap I can see that the rubber distorts. Does the wishbone pivot inside the ball or does the rubber ball move?
Thank you |
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: May 2015
Posts: 10,151
|
![]() |
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 |
Senior Member
Join Date: May 2010
Location: Coral Springs FL
Posts: 11,604
|
![]()
I think the ball moves just a little inside the rubber while serving as the rubber absorbs vibration from movement of the wishbone.
|
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: May 2010
Location: southeastern Michigan
Posts: 10,601
|
![]()
The ball end of the radius rods moves, not the rubber.
|
![]() |
![]() |
![]() |
#5 |
Senior Member
Join Date: May 2010
Location: Vernon, BC
Posts: 226
|
![]() Sponsored Links (Register now to hide all advertisements)
|
![]() |
![]() |
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|