![]() |
#1 |
Member
Join Date: May 2021
Posts: 36
|
![]()
Some of my exhaust valves are running .012 the book says they should be .015 is .012 close enough or should I have the valve stems ground down. If so what kind of grinder will I need. Some where I think I saw where they used a drill sharpener to grind the stems.
|
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: May 2010
Location: Largo Florida
Posts: 7,225
|
![]() Sponsored Links (Register now to hide all advertisements)
Apparently you have original type lifters. You might be able to find a garage with a valve grinder that can trim the ends of the valves. |
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|