![]() |
#1 |
Member
Join Date: Oct 2018
Location: Corona, CA
Posts: 58
|
![]()
Anybody know what this gauge cluster is from?
Found in the back seat of my shoebox. Looks like truck...any idea? |
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: May 2010
Location: Masterton, New Zealand
Posts: 3,998
|
![]()
the oil pressure,fuel, temp and ammeter are 1935 Ford, the speedo looks like 34 Ford
__________________
Unfortunately, two half wits don't make a whole wit! |
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 |
Member
Join Date: Oct 2018
Location: Corona, CA
Posts: 58
|
![]()
Wow. really? I was not expecting that. My family has had this car since the late 60s. I'm sure one of my uncles put that there. But none of my family members have had a 30s anything as far as I know.
|
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: May 2010
Location: Mn
Posts: 2,543
|
![]()
Curious, Does the speedometer bolt into the dash ?
I see It is rotated wrong in the hole... .
__________________
If mama ain't happy, ain't nobody happy. But if daddy ain't happy...RUN What I GOT DONE TODAY... I got the rear-end put in the recliner, and now I'm going to rest up & watch TV. ![]() |
![]() |
![]() |
![]() |
#5 |
Senior Member
Join Date: May 2010
Posts: 1,816
|
![]()
The sheet metal looks like 1935-36 pickup.
|
![]() |
![]() |
![]() |
#6 |
Senior Member
Join Date: May 2015
Posts: 10,145
|
![]() |
![]() |
![]() |
![]() |
#7 |
Senior Member
Join Date: Mar 2014
Location: Jacksonville FL
Posts: 4,804
|
![]()
IS it me OR does the arch of the top of the dash piece looks like it was a Right Hand Drive dash???? NOT that familiar with truck dashed BUT.....??? PLUS the angled right lower end of it???
|
![]() |
![]() |
![]() |
#8 |
Senior Member
Join Date: Jan 2012
Location: Lyman,ME.
Posts: 2,889
|
![]()
I don’t know zip about RHD vehicles but I’m going to agree with you....Mark
__________________
I'm thinkin' about crankin' My ragged ol' truck up and haulin' myself into town. Billy Joe Shaver…RIP |
![]() |
![]() |
![]() |
#9 | |
Senior Member
Join Date: May 2010
Location: East Shore of LAKE HOUSTON
Posts: 11,184
|
![]() Quote:
Well, going by this full dash picture and noting the upward curve of bottom of dash toward the center of such, the piece in question is probably not RHD. Interestingly, the second picture shows the long-lost, red-headed step-brother to the original subject part in bottom pic. DD ![]() …………….. |
|
![]() |
![]() |
![]() |
#10 |
Senior Member
Join Date: May 2010
Location: Star, MS
Posts: 4,120
|
![]()
the scalloped part that attaches to the windshield opening appears to me to be heading downward in the OP post while it is heading upward on the blue part shown by COOPMAN. Sometimes photographs are deceiving, though.
|
![]() |
![]() |
![]() |
#11 | |
Senior Member
Join Date: May 2010
Location: East Shore of LAKE HOUSTON
Posts: 11,184
|
![]() Quote:
Could you please elaborate? I'm not understanding! ![]() |
|
![]() |
![]() |
![]() |
#12 |
Senior Member
Join Date: May 2010
Location: Star, MS
Posts: 4,120
|
![]()
Just raising the possibility that the OP's piece MIGHT be from a right-hand drive dash. I'm looking at the top of each of those dash sections. The blue dash top appears to be rising as if it is going to the center of the windshield opening. In the OP's picture the top appears to be sloping downward as it would if it were on the right side.
|
![]() |
![]() |
![]() |
#13 | |
Senior Member
Join Date: May 2010
Location: East Shore of LAKE HOUSTON
Posts: 11,184
|
![]() Quote:
NOW I understand what you were getting at. The detail you speak of is hard for me to be sure about because the ORIGINAL piece in this thread is posed at an angle, making it sorta hard to compare. I was going by the upward sweep at the bottom/right of both pieces which I thought seemed to match the raised portion toward lower/center of the full dash pictured. DD |
|
![]() |
![]() |
![]() |
#14 |
Senior Member
Join Date: May 2010
Location: Star, MS
Posts: 4,120
|
![]()
That is probably the better indicator
|
![]() |
![]() |
![]() |
#15 |
Member
Join Date: Oct 2018
Location: Corona, CA
Posts: 58
|
![]()
And maybe the speedo being tilted is creating an illusion, making other parts seem to be more or less sloped. I’m going to try and clean it up and straighten the Speedo and take a better more straight on photo.
|
![]() |
![]() |
![]() |
#16 | |
Senior Member
Join Date: May 2010
Location: East Shore of LAKE HOUSTON
Posts: 11,184
|
![]() Quote:
At this point, does it really matter whether it's LHD or RHD? It's obviously out of a '36-ish Ford truck. DD ![]() |
|
![]() |
![]() |
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|