The Ford Barn

Terry, NJ · 02-01-2017, 05:47 PM

I know I've posted this before, but the problem still exists. I took the shifter-plate off the top of the trans and things look good in there, at least I think they do. Nothing was excessively loose Third gear (The one it jumps out of) is more of a couple of splines, than gears that mesh. A male and female that mesh. I can't see the female, but the male is a little shiny where the female (slider) goes over it. And (This may be significant) it looks like it's not going the full distance or travel. I miked the forks and the front one was .219 and the rear fork was .221. I don't know what they're supposed to be. But overall the trans is tight and it should be working fine. Any suggestions?
Terry

02-01-2017, 05:47 PM	#1
Terry, NJ Senior Member Join Date: May 2010 Location: Bucks Co, Pa Posts: 3,749	Howcum my Transmission jumps out of gear? I know I've posted this before, but the problem still exists. I took the shifter-plate off the top of the trans and things look good in there, at least I think they do. Nothing was excessively loose Third gear (The one it jumps out of) is more of a couple of splines, than gears that mesh. A male and female that mesh. I can't see the female, but the male is a little shiny where the female (slider) goes over it. And (This may be significant) it looks like it's not going the full distance or travel. I miked the forks and the front one was .219 and the rear fork was .221. I don't know what they're supposed to be. But overall the trans is tight and it should be working fine. Any suggestions? Terry