|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
05-07-2016, 09:01 AM
|
#1 |
|
Junior Member
Join Date: Oct 2015
Location: Tonawanda New York
Posts: 20
|
Model a Rumble seat
Does anyone know if a 30/31 model a rumble seat will fit in a 28/29 model a?
Any help is appreciated Thanks Tom B |
|
|
|
05-07-2016, 09:59 AM
|
#2 |
|
Senior Member
Join Date: May 2010
Location: El Segundo CA
Posts: 181
|
Re: Model a Rumble seat
I suspect it will. I know of a '30 with a '29 rumble in it.
Dick |
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
05-07-2016, 12:44 PM
|
#3 |
|
Senior Member
Join Date: May 2010
Posts: 1,816
|
Re: Model a Rumble seat
The only difference is in the Handle/latch and striker location. It's pretty much covered in this old thread:
https://www.fordbarn.com/forum/showthread.php?t=182244 |
|
|
|
|
05-08-2016, 06:08 AM
|
#4 |
|
Junior Member
Join Date: Oct 2015
Location: Tonawanda New York
Posts: 20
|
Re: Model a Rumble seat
Thanks for the help
|
|
|
|
|
05-08-2016, 06:48 AM
|
#5 |
|
Senior Member
Join Date: May 2010
Location: South East NJ
Posts: 3,398
|
Re: Model a Rumble seat
Sponsored Links (Register now to hide all advertisements)
Lids are the same with the exceptions listed above. More details about rumble seats can be found at my website link below. |
|
|
|
|
«
Previous Thread
|
Next Thread
»
Linear Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 08:40 AM.