|
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
![]() |
Thread Tools | Display Modes |
![]() |
#1 |
Senior Member
Join Date: May 2011
Location: Elyria, Ohio
Posts: 806
|
![]()
I need to remove the rear seat side panels from my 1930 Town Sedan's interior. I know the side panels are nailed to the interior's wooden frame, but how are the side arm rests fastened? I know they must be supported by some framework, but I don't see any fasteners.
Marty |
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: Mar 2015
Location: Freetown, Massachusetts
Posts: 511
|
![]()
Near the back of the armrest, (hidden when the back of the seat is in) there are a single screw, usually hidden by the fabric covering. Remove that screw, then slide the armrest forward about 1". It will then be out.
__________________
Brian French; 1930 Briggs Town Sedan |
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 |
Senior Member
Join Date: May 2010
Location: Ogden Utah
Posts: 243
|
![]()
This the same procedure on our 30 Murray Town Sedan.
|
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: May 2011
Location: Elyria, Ohio
Posts: 806
|
![]() Sponsored Links (Register now to hide all advertisements)
Marty |
![]() |
![]() |
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|