HC head on "B" block

[harleytoprock]

Can I use this head on a "B" block?
http://www.snydersantiqueauto.com/5358

If so, what gasket would be best to use?

Many thanks !

[MAG]

Yes. Use FelPro 7013 gasket with copper spray sealer. Be sure to plug the 2 holes in the block beside the center stud. Compare the head gasket to the block and the head and you will see why. Search the archives for further info. on this proceedure.

[Walt Dupont--Me.]

I plugged the 2 holes in the center of the B block when I installed the A police head. I drilled and taped the holes 1/4in. and used alen head sets screws, set them down flush with the block and filled the alen heads with J-B Weld. Walt

[harleytoprock]

I'm thinking of plugging the 2 steam holes with bolts cut near to surface and with high temp loctite. Then have the blocked decked. I wonder if plugs made of cast iron would be better so the expansion rate would be similar to the block.
I don't understand why Snyder's states that a "B" gasket should be used with 6-1 head.
Anyone know why?

[Charlie Stephens]

Sponsored Links (Register now to hide all advertisements)

Originally Posted by harleytoprock

I'm thinking of plugging the 2 steam holes with bolts cut near to surface and with high temp loctite. Then have the blocked decked. I wonder if plugs made of cast iron would be better so the expansion rate would be similar to the block.
I don't understand why Snyder's states that a "B" gasket should be used with 6-1 head.
Anyone know why?

Your going to have to ask them but I think it is probably that the B gasket follows the combustion chamber shape more closely than the A gasket.

Charlie Stephens