Battery to switch cable support assembly

[Steve Plucker]

Which is the correct mounting for the April 1928 -October 1929 Battery to switch cable support assembly?

It can go one of two ways...with the end of the "curve" towards the starter or towards the floorboard?

Thanks.

Pluck

[Tom Wesenberg]

The mounting tab that goes under the bolt is on the battery side. I might have a picture of a good original mount and rubber.

[Steve Plucker]

Thanks Tom!

Pluck

[Tom Wesenberg]

Pluck I wasn't quite sure of your question, so I reworded my answer, plus here is a picture.

[Steve Plucker]

Tom,

The part is attached to the bell housing and has the special rubber insulating grommet.

Pluck

[Tom Wesenberg]

Sponsored Links (Register now to hide all advertisements)

Here's a couple pictures of an original bracket and rubber. In the first picture, the open end of the rubber shown faces the starter switch.

[Tom Wesenberg]

Here's a picture of what's left of the original grommet on my 9-27-28.

[Marco Tahtaras]

Bulletins page 395 or Standards page 2-4

If you hold the bracket up in position you will find it can only go one way and achieve the result shown.