|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
10-21-2013, 09:14 AM
|
#1 |
|
Junior Member
Join Date: Oct 2013
Posts: 1
|
Model A Trans and Open Drive Shaft
I'm converting my Speedster back to a Model A engine and trans. The car currently has a Model A rear end with an open drive shaft, and I would like to convert the A Model A transmission to accept the open drive. I cant find a kit to do this. I can make my own, but it'll take time to build the U joint yoke and bearing retainer cap/oil seal holder.
Anyone out there with experience with this? John D Last edited by Sisuman; 10-21-2013 at 09:47 AM. |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 06:17 PM.