|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
01-09-2013, 06:32 AM
|
#1 |
|
Senior Member
Join Date: May 2010
Location: Rock Hill, S.C.
Posts: 985
|
Rear End Housing Assy Question
I would assume that you would want minimal axle shaft end play. What is recommended maximum?
I understand ring gear to pinion back lash, but do not know how it is checked on the Model A rear end. Any ideas? Can someone that has done this figure out a way to equate it as degrees of rotation on the drive shaft while holding the ring gear stationary?
__________________
Uncle Bud says "too soon old, too late smart!" |
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 01:29 AM.