The Ford Barn

Bigfoot61 · 02-28-2025, 07:14 PM

Ok, so I disassembled a headline and did not pay attention. So my question is when you insert the headlamp plug into the bulb socket should the wire harness terminals be installed first or can they be installed after the socket is assembled?

My concern is that there seems to be a slight ridge in the plug, is that to prevent the the harness terminals from pulling out?

Bigfoot61 · 02-28-2025, 07:15 PM

Supposed to be headlight, computer has its own ideas

1955cj5 · 02-28-2025, 09:16 PM

Is this the connection you are asking about?

Bigfoot61 · 03-01-2025, 05:40 AM

Sponsored Links (Register now to hide all advertisements)

Yes! That's the connector i'm talking about.

02-28-2025, 07:14 PM	#1
Bigfoot61 BANNED Join Date: Aug 2024 Location: Nampa, Idaho Posts: 14	Question for expert Ok, so I disassembled a headline and did not pay attention. So my question is when you insert the headlamp plug into the bulb socket should the wire harness terminals be installed first or can they be installed after the socket is assembled? My concern is that there seems to be a slight ridge in the plug, is that to prevent the the harness terminals from pulling out?

02-28-2025, 07:15 PM	#2
Bigfoot61 BANNED Join Date: Aug 2024 Location: Nampa, Idaho Posts: 14	Re: Question for expert Supposed to be headlight, computer has its own ideas

03-01-2025, 05:40 AM	#4
Bigfoot61 BANNED Join Date: Aug 2024 Location: Nampa, Idaho Posts: 14	Re: Question for expert Sponsored Links (Register now to hide all advertisements) Yes! That's the connector i'm talking about.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode