|
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
![]() |
Thread Tools | Display Modes |
![]() |
#1 |
Senior Member
Join Date: Feb 2019
Location: Atlanta, GA
Posts: 433
|
![]()
Can the rear bumper brackets that bolt to the frame and the crossbar be removed and re-installed without lifting the body so they could be media blasted and repainted?
|
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: Jun 2010
Location: San Antonio, Texas
Posts: 17,410
|
![]()
A lot depends on what condition the bolts that go through the frame are in. The type of body can have an affect too. The sub rails set on blocks but the edges are close to the frame rails.
Last edited by rotorwrench; 08-02-2024 at 10:08 AM. |
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 |
Senior Member
Join Date: May 2010
Location: Long Island, NY
Posts: 4,112
|
![]()
There is one bolt on each arm that is trapped by the body. If you remove the arms, see the sketch below.
__________________
Bob Bidonde |
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: Feb 2019
Location: Atlanta, GA
Posts: 433
|
![]() Sponsored Links (Register now to hide all advertisements)
|
![]() |
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|