|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
12-31-2017, 05:22 PM
|
#1 |
|
Senior Member
Join Date: May 2010
Posts: 1,369
|
Clam shell question
The finger on the upper shell half is right on the frame cross member. It is the first time I have actually seen this shell version on a car, so I don't know what proximity it should be from that frame section. Could this be indicative of frame sag? The rear engine mounts are stock and all the sheet metal gaps look good.
Last edited by Great Lakes Greg; 12-31-2017 at 05:24 PM. Reason: addition |
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 08:26 PM.