|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
08-06-2015, 07:09 PM
|
#1 |
|
Senior Member
Join Date: Oct 2011
Location: Falmouth, Ma.
Posts: 313
|
re seating of needle valve?
i have read about lengthening an old needle valve and then putting it in a drill and then using it to hone out the carburetor casting where the needle valve sits. is this actually possible? when i turn the gas adjustment valve all the way in it has little or no affect. this carb does not have a needle seat that is replaceable. thanks.
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 06:19 PM.