49-54 Generator Mounting

[John R]

The several 49-53 generators I’ve handled have two ¼” locating holes. The rear hole works for my setup which is a single, wide-belt on a V8. What is the front hole for? The dual, narrow-belt setup or maybe a 6-cylinder?

[petehoovie]

Originally Posted by John R

The several 49-53 generators I’ve handled have two ¼” locating holes. The rear hole works for my setup which is a single, wide-belt on a V8. What is the front hole for? The dual, narrow-belt setup or maybe a 6-cylinder?

[John R]

Amazing! No answers have been posted regarding the rather simple question I posed. it can't be that complicated, can it?

[tubman]

Nice. Give it at least a day, will ya.

[19Fordy]

Is it possible that the 2 holes are used to accommodate the use of a 2 sheave generator pulley?

[deuce5wndw]

Sponsored Links (Register now to hide all advertisements)

Maybe one for the car and one for the truck engine?

[Rangerstan]

I use the front hole on my 1951 6 cylinder with the narrow pulley/belt.

[tubman]

And there you have it. It's for mounting the same generator on different applications.

And it only took 6 days.

[Bob C]

1948 6cyl F2 real wide belt uses back hole.

[John R]

Originally Posted by Rangerstan

I use the front hole on my 1951 6 cylinder with the narrow pulley/belt.

Thanks Stan. The answer to my simple question finally emerges. There's just not very many of you 6-cyl folks around I guess.
John

[kirkf]

None of my 49-53 Generators have two holes.
(I've got about 6 of them in various condition in the shed)

This may be because there was no 6 cylinder option in Canada?

Kirk

[ndnchf]

Here is a 2-hole 8ba narrow belt generator on my bench for restoration.

[petehoovie]

Originally Posted by ndnchf

Here is a 2-hole 8ba narrow belt generator on my bench for restoration.

[Brian]

2nd hole for correct orientation of fanbelt when used on a tractor? 8N?

[ndnchf]

8N uses a different generator.