|
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
![]() |
Thread Tools | Display Modes |
![]() |
#1 |
Junior Member
Join Date: Mar 2014
Location: Socal
Posts: 9
|
![]()
All of the tack strips on my '33 two door are shot.
They are either gone as on the top or partially gone or have turned to stone (in the interior). What have you done to solve this problem? |
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: May 2010
Location: on the Littlefield
Posts: 6,555
|
![]()
one of me cars has twisted paper tack strips that were bad,the replacement plastic stuff didn’t fit properly, adding pieces of old round extension cord pieces underneath allowed the use of the modern material
|
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 |
Senior Member
Join Date: May 2010
Location: Wisconsin, USA
Posts: 9,852
|
![]()
The modern nylon tack strip is available in many widths and thicknesses. It is far superior to the original paper strip. The nylon does not absorb moisture, and it holds tacks extremely well.
When I install it to the body belt, I place a fastener every 2 1/2".
__________________
"I can explain it for you. However, I can't understand it for you". |
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: May 2010
Posts: 5,170
|
![]()
Drake offers a variety of tack strip material in different widths and thickness.
|
![]() |
![]() |
![]() |
#5 |
Senior Member
Join Date: May 2010
Location: Napa,California
Posts: 6,566
|
![]()
Mike is "spot on" regarding the nylon tack strip, You can get different widths and thickness. It definitely holds the tacks or staples. For stapling I use one of the "cheapo" air staplers from Harbor Freight.
|
![]() |
![]() |
![]() |
#6 |
Senior Member
Join Date: May 2010
Location: Midland Park, NJ
Posts: 4,290
|
![]() Sponsored Links (Register now to hide all advertisements)
__________________
48 Ford Conv 56 Tbird 54 Ford Victoria |
![]() |
![]() |
![]() |
#7 |
Senior Member
Join Date: May 2010
Location: Minnesota
Posts: 2,027
|
![]()
For the top on a '33 Tudor we did; carefully removed what remained of the original tack strip material from the metal tin channel it was crimped in, then drilled out the rivets holding the tin channel to the roof, had the tin channel blasted and powder coated, fitted new plastic strip in to the tin channel with sealer, holding it to the outside of the channel as the plastic was a little narrower than the original stuff, then riveted the rebuilt tin channel/plastic tack strip assy back onto the body with sealer, and after paint, installed the top as normal.
Easier to do than explain. |
![]() |
![]() |
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|