What Is This?

[shew01]

Does anyone recognize this part? What is it? It came with Model A parts. It looks to be brass.








Sent from my iPhone using Tapatalk

[mcgarrett]

I believe it is the brass bushing that the front engine mount rests on. The bushing goes into a hole in the front crossmember and the engine mount stud and spring are inserted into it.

https://www.snydersantiqueauto.com/p...8649&cat=41692

[Y-Blockhead]

Originally Posted by mcgarrett

I believe it is the brass bushing that the front engine mount rests on. The bushing goes into a hole in the front crossmember and the engine mount stud and spring are inserted into it.

https://www.snydersantiqueauto.com/p...8649&cat=41692

I believe magarret is correct.

[MrBruce]

Front motor mount under the Yoke and cross member. Just read not long ago that Ford discontinued the bushing but just used two of them on two engines.

[alexiskai]

Deleted

[alexiskai]

Sponsored Links (Register now to hide all advertisements)

Originally Posted by MrBruce

Front motor mount under the Yoke and cross member. Just read not long ago that Ford discontinued the bushing but just used two of them on two engines.

The reproduction bushing is made to fit front crossmembers that never had the bushing to begin with. It's a weird setup. It's not bad to use them, they don't hurt anything, but in most cases it's not "correct."

[ursus]

Is this installed up from under the cross member or down from above?

[Y-Blockhead]

Originally Posted by ursus

Is this installed up from under the cross member or down from above?

Mine is installed from the bottom, then the spring, nut, cotter pin.

[shew01]

Thanks, everyone. I did not know that there was such a thing.


Sent from my iPhone using Tapatalk

[GMCPASO]

Washer/ bushing at the center of the front motor mount mounted below the frame with spring pushing it up. Use it if you want if all is centered.