|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
07-08-2023, 06:54 AM
|
#1 |
|
Senior Member
Join Date: May 2018
Location: Tallahassee
Posts: 375
|
Eddie Meyer aluminum heads
Hey Guys,
I have a 21 stud flathead with Eddie Meyer heads. My research shows that the heads are rated 8.25:1 CR but my heads are about 89-90 lbs at each cylinder. If my math is correct, this comes out to around 6:1 compression. The engine was built by H & H Flatheads and has about 800 miles on it. Any ideas why such a discrepancy? Richard |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 11:57 PM.