|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
08-05-2022, 07:41 AM
|
#1 |
|
Senior Member
Join Date: Jun 2015
Posts: 171
|
U Joint Retainer Washer
As with most aftermarket parts I have sanded a little bit off of the A-7095 U Joint Retainer Washer so that it will sit in the recess of the U joint knuckle. My question is when the knuckle slips on to the A-7060 Main Shaft there is a gap of about .060" between the shaft and retainer which would make the washer deform when tightened. Is this correct?
Thanks, for your help. |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 04:13 PM.