Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 09-11-2017, 08:35 AM   #1
dan ia
Junior Member
 
Join Date: May 2010
Location: Southwest Iowa
Posts: 22
Default Starting for the first time in 10 years!

Good morning, I normally hang out in the early V8 forum, but look here time to time... I have recently started working on a 1930 Coupe that my grandfather owned, it has been sitting for a little over 10 years since it ran. It did run great when it was put away. I have gone through all the normal things to start her back up: changed fluids, spark plugs, checked timing (it has spark), drained gas/filled with new and replaced the shut off valve, it has a marvel schebler carb, took that off and cleaned it all out. Now, it will start up on full choke but only runs for a couple of seconds then dies... it almost acts like its not getting enough fuel.

My question: is there anything special that I need to be doing with this carb to set it up?? I have messed with the GAV and opened it up more which seemed to help at first. I have had a hard time getting information on this model carb.

Also, is it possible that its dying because it is losing spark?
dan ia is offline   Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 05:09 PM.