B head inquiry.

[Tod]

I was contacted about an old post I made about B heads. The question regarded making one that was basically stock looking yet having a high-compression chamber. Today I took some time to do a little model work in that direction. I figure I would use the Snyder 6:1 chamber with all its internal strengthening ribs. They would be available in iron or aluminum.

It seems these would be in far less demand than other heads and would be more expensive due to less interest. But, if enough people are interested a short run could get pricing down.

Note: The picture shows an incomplete model. I need to place the spark plug bosses where the chamber dictates.

Tod