Front radius Socket

[Beauford]

I have a new radius kit. I assume this solid piece needs to come out?? Was this for the rubber ball? If this does come out, how so? Been in 90 years....

[Tom Wesenberg]

Just pull it down and out, then slip in the correct stamped steel plate with the oil hole.

Then the ball with lots of grease on it, then the bottom plate with no hole. slip the sleeve onto the bolts. The springs push the bottom plate up, and the nuts and cotters go on last.

[Beauford]

Sponsored Links (Register now to hide all advertisements)

Thank you once again Tom! As a older gentleman told me..."well son you got a hell of a project but the good thing doing it this way, if you break down you will be able to figure it out"