Go Back   The Ford Barn > General Discussion > Model T (1909-1927)
Reload this Page Engine Block Question

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 03-08-2016, 12:16 AM   #1
Bob from Northport
Senior Member
 
Bob from Northport's Avatar
 
Join Date: May 2010
Location: 215 E. 6th Street Northport, Michigan 49670
Posts: 1,004
Default Engine Block Question
We T engines were first manufactured, were the cylinders sleeved, or was the block bored through the casting??

Thanks!!
__________________
Bob from Northport
Northport, Michigan
Bob from Northport is offline   Reply With Quote
Old 03-08-2016, 12:51 AM   #2
redmodelt
Senior Member
 
redmodelt's Avatar
 
Join Date: May 2010
Location: Portland OR
Posts: 6,408
Default Re: Engine Block Question
Basically the same as a Model A.
redmodelt is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Old 03-08-2016, 07:48 AM   #3
trainguy
Senior Member
 
trainguy's Avatar
 
Join Date: May 2010
Location: Lehighton Pa
Posts: 1,085
Default Re: Engine Block Question
No factory sleeves.
trainguy is offline   Reply With Quote
Old 03-08-2016, 09:09 AM   #4
tmodelman
Senior Member
 
Join Date: May 2010
Posts: 580
Default Re: Engine Block Question
Sponsored Links (Register now to hide all advertisements)
Gang milling of newly cast blocks...moving about in the huge Ford Highland Park plant.
Attached Images
File Type: jpg IMG_4717 (600x450).jpg (196.2 KB, 25 views)
File Type: jpg IMG_4713 (600x448).jpg (205.3 KB, 15 views)
tmodelman is offline   Reply With Quote
Reply

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 08:52 AM.