The Ford Barn

Jon-Ohio · 08-08-2015, 01:02 PM

Was wondering how to set the float level on the Marvel Schebler carb ?

Thanks for any info

Jon in Ohio

roccaas · 08-08-2015, 02:37 PM

Not sure, but when mine gets back from:

http://rennerscorner.com/index.html

PM me and I'll pull the float measurement for you!

Jeff in BC · 08-08-2015, 02:46 PM

Hi Jon
Maybe some of the information in this post will help you.
https://www.fordbarn.com/forum/showthread.php?t=139836

Jeff

Jon-Ohio · 08-08-2015, 03:23 PM

Sponsored Links (Register now to hide all advertisements)

Thanks Jeff - you answered my question in your MS thread:

Quoting Jeff from his well written MS thread:

"Service Note: Setting float height, the float should be parallel to the upper gasket surface. I used the float seam to gasket surface (15/16"). In the photo it looks a little off but this is camera distortion. If measured as shown the clearance between the gasket surface and the top of the float is 1/4". The height from the gasket surface to the bottom of the float is 1 3/4".

08-08-2015, 01:02 PM	#1
Jon-Ohio Senior Member Join Date: May 2010 Posts: 191	Marvel Schebler float depth ? Was wondering how to set the float level on the Marvel Schebler carb ? Thanks for any info Jon in Ohio

08-08-2015, 02:37 PM	#2
roccaas Senior Member Join Date: May 2010 Location: Savannah, GA Posts: 1,300	Re: Marvel Schebler float depth ? Not sure, but when mine gets back from: http://rennerscorner.com/index.html PM me and I'll pull the float measurement for you! __________________ 20 years ago we had Johnny Cash, Steve Jobs, and Bob Hope. Now we have no Cash, no Jobs, and no Hope...please don't let Kevin Bacon die!

08-08-2015, 02:46 PM	#3
Jeff in BC Member Join Date: May 2010 Location: Gabriola BC Posts: 58	Re: Marvel Schebler float depth ? Hi Jon Maybe some of the information in this post will help you. https://www.fordbarn.com/forum/showthread.php?t=139836 Jeff

08-08-2015, 03:23 PM	#4
Jon-Ohio Senior Member Join Date: May 2010 Posts: 191	Re: Marvel Schebler float depth ? Sponsored Links (Register now to hide all advertisements) Thanks Jeff - you answered my question in your MS thread: Quoting Jeff from his well written MS thread: "Service Note: Setting float height, the float should be parallel to the upper gasket surface. I used the float seam to gasket surface (15/16"). In the photo it looks a little off but this is camera distortion. If measured as shown the clearance between the gasket surface and the top of the float is 1/4". The height from the gasket surface to the bottom of the float is 1 3/4".