|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
08-05-2016, 12:07 PM
|
#1 |
|
Member
Join Date: May 2010
Location: Devils Lake ND
Posts: 45
|
crank shaft pulley
crank pulley is loose and rattles. It looks like not enough room to take off unless I remove the U bolts from the front spring or raise the engine a little. If I loosen the front motor mounts and then I,m not sure about the rear mounts. This on a 1933 Ford 1 1/2 ton truck. Need advice! HELP
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 09:27 AM.