The Ford Barn

mrtexas · 05-31-2016, 07:00 PM

Getting ready for a Mitchell OD. Will I have to grind off one end of the pins that hold the driveshaft down on a 41 rear end?

john in illinois · 06-01-2016, 07:52 AM

Sponsored Links (Register now to hide all advertisements)

I drill the pin to remove peened end and then drive it out. I support shaft with a heavy hammer to protect bearings.

John

05-31-2016, 07:00 PM	#1
mrtexas Senior Member Join Date: May 2010 Location: Sugar Land, TX Posts: 4,395	41 driveshaft breakdown Getting ready for a Mitchell OD. Will I have to grind off one end of the pins that hold the driveshaft down on a 41 rear end?

06-01-2016, 07:52 AM	#2
john in illinois Senior Member Join Date: May 2010 Location: Illinois Posts: 2,189	Re: 41 driveshaft breakdown Sponsored Links (Register now to hide all advertisements) I drill the pin to remove peened end and then drive it out. I support shaft with a heavy hammer to protect bearings. John