![]() |
#1 |
Member
Join Date: Apr 2016
Posts: 94
|
![]()
Hello. I just installed a clings adapter and a 1939 trans in my model a. When I hooked the clutch pedal up it just falls to the floor. Opened the inspection plate and noticed that the throw out bearing isn’t touching the fingers. The fingers have no play in them when I push them with a screwdriver like the throw out bearing would. Any ideas what could be wrong not? Clutch and pressure plate are new
|
![]() |
![]() |
![]() |
#2 |
Member
Join Date: Apr 2016
Posts: 94
|
![]()
Here’s some pictures
|
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 |
Junior Member
Join Date: Oct 2012
Posts: 21
|
![]()
Need to adjust the clutch rod. Just went through that process with a v8 pressure plate'
John |
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: Sep 2020
Location: Yorktown Virginia
Posts: 184
|
![]()
I hate to say this but just saw a similar issue and it was the clutch plate installed backwards
|
![]() |
![]() |
![]() |
#5 |
Member
Join Date: Apr 2016
Posts: 94
|
![]()
Can’t the clutch only go on one way? It sits flush one way and not flush the other.
|
![]() |
![]() |
![]() |
#6 |
Member
Join Date: Apr 2016
Posts: 94
|
![]() Sponsored Links (Register now to hide all advertisements)
|
![]() |
![]() |
![]() |
#7 |
Senior Member
Join Date: Jun 2015
Location: Red Deer, Alberta
Posts: 5,104
|
![]()
Got a picture of the clutch linkage?
__________________
If you don't hear a rumor by 10 AM, start one!. Got my education out behind the barn! |
![]() |
![]() |
![]() |
#8 |
Member
Join Date: Apr 2016
Posts: 94
|
![]()
This is all I have with me
|
![]() |
![]() |
![]() |
#9 |
Member
Join Date: Apr 2016
Posts: 94
|
![]()
Linkage
|
![]() |
![]() |
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|