|
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
![]() |
Thread Tools | Display Modes |
![]() |
#1 |
Senior Member
Join Date: May 2010
Location: Nelson. New Zealand
Posts: 2,010
|
![]()
Recently a custmer came in with an unusual Model A generator . I have never seen one like this & maybe its from a Ford tractor, It has FORD X 9 on the case, A cast front to the case, rear cover has the terminal on it rather than on top where the cut out goes plus a screw that one ajusts for the output marked hi & low. It mounts to engine same way as normal A one, Anyone shed some light on the above , Hope pictures show the points i have stated , Thanks in advance,
|
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,821
|
![]()
Yep Ford tractor, I have one just like it on my 2N.
Bob |
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 |
Senior Member
Join Date: Oct 2011
Location: south australia
Posts: 166
|
![]()
Low output completely sealed to keep dust out. Tractor for sure.
|
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: May 2010
Location: Southbridge, Ma.
Posts: 1,614
|
![]()
I have one on my doodlebug that came off my 2N tractor. Works good and easy to adjust output. Just had to add a cutout.
|
![]() |
![]() |
![]() |
#5 |
Senior Member
Join Date: May 2010
Location: Alabama
Posts: 8,099
|
![]() Sponsored Links (Register now to hide all advertisements)
|
![]() |
![]() |
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|