|
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
![]() |
Thread Tools | Display Modes |
![]() |
#1 |
Junior Member
Join Date: Feb 2014
Posts: 6
|
![]()
I’ve Been working on my windshield wiper motor after removing the motor cover and setting it a side I completed my inspection of the brushes and cleaned it up a bit with wd 40. The cover has some small dents and chips in the paint so while I have it off I decided to repaint it. after closer inspection I started picking at one of the chips and it appeared to be brass under the paint. Used a razor blade to remove the paint wet sanded a section of the cover and used never-dull, wow it look great. Am I correct in assuming it came form the factory unpainted brass ?
Thanks Paul |
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: Jun 2017
Location: Walla Walla, WA
Posts: 1,047
|
![]()
I am pretty sure nothing on the Model A was bare brass. I seem to recall that the judging standards say black.
|
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 |
Senior Member
Join Date: Jun 2010
Location: San Diego, CA
Posts: 1,489
|
![]()
It sounds like you have a Heinze wiper HA-C1 with the brass cover. It was originally dipped in gloss black enamel.
|
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: Jun 2010
Location: San Antonio, Texas
Posts: 16,532
|
![]()
No polished brass one that I'm aware of.
|
![]() |
![]() |
![]() |
#5 |
Junior Member
Join Date: Feb 2014
Posts: 6
|
![]() Sponsored Links (Register now to hide all advertisements)
|
![]() |
![]() |
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|