Valve lifter bore grinding - The Ford Barn

		The Ford Barn > General Discussion > Early V8 (1932-53)
Valve lifter bore grinding

Sponsored Links (Register now to hide all advertisements)

Prev

Previous Post

Next Post

Next

02-12-2013, 12:25 AM	#1
Kahuna Senior Member Join Date: May 2010 Location: NorCal Posts: 2,617	Valve lifter bore grinding For you flathead builders, what is the reason for the tops of the lifter bores being ground down a bit? Is this to make it easier to check the adjustment with adjustable lifters? I know about drilling of the bores to ease adjustment using a drift, but am wondering about grinding the tops of the bores? Thanks for the insight Jim

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Sponsored Links (Register now to hide all advertisements)

All times are GMT -5. The time now is 04:33 PM.