The Ford Barn

mcgarrett · 08-26-2022, 10:08 PM

My '30 Roadster rumble seat riser/platform has a factory punched hole at each end of the leading edge of the platform about 1 inch from the edge. I would assume they are to attach some type of stop pin or stud to keep the rumble seat cushion in place, but my car doesn't have the studs. I checked Bratton's website and they show the platform but no mention of any stud or pin for the holes:

https://www.brattons.com/28-31-RUMBL...uctinfo/35110/

Is there a specific pin or stud that should go there and where can I find them?
Appreciate the feedback.

08-26-2022, 10:08 PM	#1
mcgarrett Senior Member Join Date: Dec 2013 Location: Corsicana, Texas Posts: 1,306	What goes in the holes of a rumble seat riser? My '30 Roadster rumble seat riser/platform has a factory punched hole at each end of the leading edge of the platform about 1 inch from the edge. I would assume they are to attach some type of stop pin or stud to keep the rumble seat cushion in place, but my car doesn't have the studs. I checked Bratton's website and they show the platform but no mention of any stud or pin for the holes: https://www.brattons.com/28-31-RUMBL...uctinfo/35110/ Is there a specific pin or stud that should go there and where can I find them? Appreciate the feedback.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode