Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)
Reload this Page Lifting cab on 35 PU

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 06-18-2016, 11:23 AM   #1
Lawson Cox
Senior Member
 
Lawson Cox's Avatar
 
Join Date: May 2010
Location: Above the gnat line in Georgia
Posts: 7,079
Default Lifting cab on 35 PU
I am thinking of lowering the cab a tad on my pickup to get the belt molding on the cab to align with the belt molding on the hood. Can't do it very easy by trying to align radiator end. Too much out of line to just adjust hood itself. I think I can loosen cab bolts and jack cab up enough to remove long wooden supports and trim them a little to make it right. HAS ANYONE DONE THIS? AM I DREAMING???

Any suggestions or comments welcome.

Thanks in advance.
__________________
Life is like a roll of toilet paper. The closer to the end, the faster it goes.

It is better to be seen, than viewed.

"We sleep safe in our beds because rough men stand ready in the night to visit violence on those who would do us harm".
Lawson Cox is offline   Reply With Quote
 

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Threaded Mode Threaded Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 07:59 AM.