throttle travel question - The Ford Barn

		The Ford Barn > General Discussion > Model A (1928-31)
throttle travel question

Sponsored Links (Register now to hide all advertisements)

Prev

Previous Post

Next Post

Next

07-04-2014, 09:21 AM	#1
Al 29Tudor Senior Member Join Date: Jul 2012 Location: Venice, FL Posts: 667	throttle travel question Good morning, The throttle plate in the carburetor does not open all the way because the linkage hits the bell housing before it is fully open. What is the linkage made of? If it is cast I can't bend it but if not I'll take a chance. Have you guys done this without heating it or must it be bent with heat? Is this a common issue? Thanks for your help, Al

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Sponsored Links (Register now to hide all advertisements)

All times are GMT -5. The time now is 09:20 PM.