The Ford Barn - View Single Post

Jim Brierley · 05-21-2014, 10:58 AM

tod, no need to allow .005 to be honed. i only leave .0005 - .001, thus requiring less honing, which is hard work if doing manually. goog luck on the rest of the project!

05-21-2014, 10:58 AM	#9
Jim Brierley Senior Member Join Date: Jun 2010 Location: Temecula, CA Posts: 4,251	Re: New block update 3. tod, no need to allow .005 to be honed. i only leave .0005 - .001, thus requiring less honing, which is hard work if doing manually. goog luck on the rest of the project!