The Ford Barn - View Single Post

glennpm · 06-22-2025, 10:44 AM

A couple of pictures below. With the timing cover pin aligned with the dimple in the crankshaft pulley, it is supposed to be 2° BTDC. You may have to uses the zip tie method to accurately determine TDC and then mark your pulley, in alignment with the pin.

Glenn

06-22-2025, 10:44 AM	#2
glennpm Senior Member Join Date: Sep 2014 Location: Mid-Coast Maine Posts: 2,815	Re: 8BA timing mark A couple of pictures below. With the timing cover pin aligned with the dimple in the crankshaft pulley, it is supposed to be 2° BTDC. You may have to uses the zip tie method to accurately determine TDC and then mark your pulley, in alignment with the pin. Glenn __________________ Archives of historical but relevant older articles: ------------- Hover mouse over the links below and click! ~~~~~~~~~~~~~~~~~--------------- Rumble Seat's Notes Techno-Source-for-the-1932-thru-1953-Flathead-Ford Last edited by glennpm; 06-22-2025 at 12:39 PM.