The Ford Barn - View Single Post

mach0415 · 04-19-2020, 07:11 AM

Thanks for the response. I may just run a stamped version and seek to restore this one at a later time. It would appear that points have grown about 1/8 inch over the years too, so the contacts do not meet well. Perhaps in that time I may find some that do.

04-19-2020, 07:11 AM	#3
mach0415 Senior Member Join Date: Jul 2011 Location: Chester, SC Posts: 162	Re: Distributor Upper Contact Plate Thanks for the response. I may just run a stamped version and seek to restore this one at a later time. It would appear that points have grown about 1/8 inch over the years too, so the contacts do not meet well. Perhaps in that time I may find some that do. __________________ Thanks, Mark in SC "We the unwilling, led by the unknowing, are doing the impossible for the ungrateful." -- By society, who is still arguing over who said it.