The Ford Barn - View Single Post

36coupe · 10-13-2018, 03:38 PM

I plan to build a sleeve for my T170 input shaft so I can use a and early through out bearing. A couple of questions.
1/ how tight should the ID be on the sleeve going over the transmission shaft?
2/ what is the best material to use?

Thanks

10-13-2018, 03:38 PM	#1
36coupe Senior Member Join Date: Oct 2012 Location: Eastcoast Posts: 883	Building a sleeve for a t170 I plan to build a sleeve for my T170 input shaft so I can use a and early through out bearing. A couple of questions. 1/ how tight should the ID be on the sleeve going over the transmission shaft? 2/ what is the best material to use? Thanks