The Ford Barn - View Single Post

PC/SR · 01-02-2017, 02:44 PM

Just measured a brass one, and the thrust face thickness is .110. Call Brattons or Snyders tomorrow and I am sure either would measure what they have in stock for you. They are both good and helpful folks.

01-02-2017, 02:44 PM	#7
PC/SR Senior Member Join Date: May 2010 Location: Santa Rosa, CA Posts: 1,285	Re: Crankshaft end play Just measured a brass one, and the thrust face thickness is .110. Call Brattons or Snyders tomorrow and I am sure either would measure what they have in stock for you. They are both good and helpful folks.