Forum: Early V8 (1932-53)
06-12-2023, 05:06 PM
|
Replies: 13
Views: 729
|
Forum: Early V8 (1932-53)
06-12-2023, 01:15 PM
|
Replies: 13
Views: 729
|
Forum: Early V8 (1932-53)
06-10-2023, 09:06 AM
|
Replies: 13
Views: 729
|
Forum: Early V8 (1932-53)
06-10-2023, 09:04 AM
|
Replies: 13
Views: 729
|
Forum: Early V8 (1932-53)
06-09-2023, 11:42 PM
|
Replies: 13
Views: 729
52 brake pulls hard right and squeals
right side new w cyl good stream from hose when bled squeal and pulls r then quits for a while any help app just opened em up again everything ive read says front shoe is shorter ...
|
Forum: Early V8 (1932-53)
09-07-2020, 11:20 AM
|
Replies: 8
Views: 1,103
|
Forum: Early V8 (1932-53)
09-07-2020, 11:17 AM
|
Replies: 8
Views: 1,103
|
Forum: Early V8 (1932-53)
09-07-2020, 09:26 AM
|
Replies: 8
Views: 1,103
1952 ford flathead AUTOMATIC
gonna take the wife out for a labor day spin pull the choke out pretty far have to with this one till starts runnning smooth.....so just sitting there for a few all of a sudden transmission...
|
Forum: Early V8 (1932-53)
05-13-2020, 05:13 AM
|
Replies: 11
Views: 1,406
Re: 1952 ford car clutch install
A bones a friend put the clutch in who is very familiar with ford clutches he has a 53 truck i suspect the pressure plate surface surface was not cleaned if not will it wear off
|
Forum: Early V8 (1932-53)
05-13-2020, 04:58 AM
|
Replies: 11
Views: 1,406
Re: 1952 ford car clutch install
thanks all were working on it...... one thing when i took the pressure plate out of the box and saw the fingers i thought those dont look good poor casting or machining to me clutch and...
|
Forum: Early V8 (1932-53)
05-11-2020, 03:32 PM
|
Replies: 11
Views: 1,406
Re: 1952 ford car clutch install
there was absolutely 0 chatter on old clutch motor mounts were replaced about 4 years ago when replaced w pumps flywheel was not burnt in spots and no cracks so did not resurface.......wish i had...
|
Forum: Early V8 (1932-53)
05-11-2020, 02:57 PM
|
Replies: 11
Views: 1,406
1952 ford car clutch install
clutch pp and throw out bearing prior clutch engaging pretty far out 1still engaging far out at what inch from floor should it engage my manual doesnt say and how to adjust 2 clutch...
|
Forum: Early V8 (1932-53)
10-25-2019, 09:42 AM
|
Replies: 4
Views: 1,014
|
Forum: Early V8 (1932-53)
10-24-2019, 12:50 PM
|
Replies: 4
Views: 1,014
1952 ford customline
1952 ford stick transmission and rear end what value oil /grease do they take dennis,,,,, ive been told 80/90 .... others said 140
|
Forum: Early V8 (1932-53)
09-28-2019, 03:18 PM
|
Replies: 17
Views: 2,406
Re: 1952 customline gas gauge reads near full
the irony of this whole durn thing is when you purchase these new senders after market they say on instructions FOR ORIGINAL GAUGES AND TANKS ONLY....................i am on num 6 and not buying...
|
Forum: Early V8 (1932-53)
09-28-2019, 03:10 PM
|
Replies: 17
Views: 2,406
Re: 1952 customline gas gauge reads near full
19Fordy and all interested put a 25 ohm r in and read just above 1/4 the 25 was a variable resister set for 25 since i had a 10 ohm ordered waited for it put in today and it reads about...
|
Forum: Early V8 (1932-53)
09-25-2019, 09:11 PM
|
Replies: 17
Views: 2,406
|
Forum: Early V8 (1932-53)
09-24-2019, 02:32 PM
|
Replies: 17
Views: 2,406
|
Forum: Early V8 (1932-53)
09-24-2019, 12:19 PM
|
Replies: 17
Views: 2,406
|
Forum: Early V8 (1932-53)
09-24-2019, 07:55 AM
|
Replies: 17
Views: 2,406
Re: 1952 customline gas gauge reads near full
was suggested to put a resister inline 50 ohms put one in and read real low was suggested to put a lower ohms resis in,,, working on that now but my question is what should the resistor wattage be or...
|
Forum: Early V8 (1932-53)
09-23-2019, 08:26 PM
|
Replies: 17
Views: 2,406
1952 customline gas gauge reads near full
fifth tank sender think said had new resistance style still reading high close to full,,,,,,battry reads 6.30v,,, at sender reads 6.30v, when read through sender when hooked up see 3.5v any...
|
Forum: Early V8 (1932-53)
04-26-2019, 04:18 PM
|
Replies: 23
Views: 4,050
Re: 1952 ford customline fuel sending unit
Anteek29 tried a 50 ohm 10 watt resister put in where wire connects at left tail light area ????? gauge went from E to about 1/4 E extremely slow with tank being pretty full was yours a...
|
Forum: Early V8 (1932-53)
03-27-2019, 03:19 PM
|
Replies: 23
Views: 4,050
Re: 1952 ford customline fuel sending unit
perhaps the op keeps doing open ended replays because he is 80 with beginning dementia and loves his cars and still trys working on em ... so with that this will be my last post to ford barn if i...
|
Forum: Early V8 (1932-53)
03-25-2019, 08:02 PM
|
Replies: 23
Views: 4,050
|
Forum: Early V8 (1932-53)
03-25-2019, 12:19 PM
|
Replies: 23
Views: 4,050
Re: 1952 ford customline fuel sending unit
JSeery gauge stays on full when not full test manually gauge will go from full to to low so works not installed took a voltage reading at battery battery is 6.5volts took a reading...
|