Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.09 seconds.
Search: Posts Made By: Terry,OH
Forum: Early V8 (1932-53) Today, 06:04 AM
Replies: 4
Views: 88
Posted By Terry,OH
Re: new engine start-up problems

Beside above suggestion from Bursonaw check the ignition wiring to the coil and ignition switch.
Forum: Early V8 (1932-53) 09-22-2020, 06:20 AM
Replies: 13
Views: 524
Posted By Terry,OH
Re: syncro hub position for second

I am confused, the hub is the center part of the syncro and the syncro sleeve is the outer part. On the early syncro with 6 steel balls the hub moves on the splined shaft and the later syncros with...
Forum: Early V8 (1932-53) 09-16-2020, 11:12 AM
Replies: 6
Views: 232
Posted By Terry,OH
Re: Steering gear box leak

No seal there, leave the box empty of lube until after reinstalled.
Forum: Early V8 (1932-53) 09-16-2020, 06:40 AM
Replies: 15
Views: 594
Posted By Terry,OH
Re: 1936 Overheating Problem

35-6 are prone to over heat issues. Ford added modifications to several items such as louvers to the inner fender panels of 36 to improve cooling but they work best when the car is moving. IMO I...
Forum: Early V8 (1932-53) 09-15-2020, 06:25 AM
Replies: 11
Views: 312
Posted By Terry,OH
Re: Gas tank sender unit.

Look the sender over VERY closely even with a magnifying glass to make sure there are no cracks in ANY solder joint especially where the tubes go through the mounting plate and where they enter the...
Forum: Early V8 (1932-53) 09-15-2020, 06:15 AM
Replies: 7
Views: 333
Posted By Terry,OH
Re: 1937 Ford V8 Steering Box Bushes

They do look correct to me also. You can not hammer the new bushings into place and they MUST be started evenly.
Forum: Early V8 (1932-53) 09-15-2020, 06:11 AM
Replies: 11
Views: 418
Posted By Terry,OH
Re: adjusting 39 Ford pickup shocks

The small adjustment usually makes a very big difference. are the shocks full of fluid? Go ahead and move the pointer 3/8" When were the shocks rebuilt?
Forum: Early V8 (1932-53) 09-13-2020, 06:03 AM
Replies: 12
Views: 544
Posted By Terry,OH
Re: 1935 Ford Pickup Transmission hard to get into reverse! HELP!

Hard to tell what is the problem from here but if you have not rebuilt the top shift mechanism it may be time. Does the problem occur at idle, while down shifting, with engine off??? A bit more info...
Forum: Early V8 (1932-53) 09-13-2020, 05:50 AM
Replies: 11
Views: 418
Posted By Terry,OH
Re: adjusting 39 Ford pickup shocks

Turn CW to increase resistance and CCW for less. Suggest you take a note of your start point and only move about 1/32" at a time.
Forum: Early V8 (1932-53) 09-07-2020, 04:32 PM
Replies: 34
Views: 1,031
Posted By Terry,OH
Re: Do you think a sleeve will fix this?

check out some of the thick wall sleeves. They can be sealed so there is no water seepage. I have seen holes as big as a walnut in a bore repaired.
Forum: Early V8 (1932-53) 09-07-2020, 09:35 AM
Replies: 3
Views: 240
Posted By Terry,OH
Re: Mystery gauge...Speedo??

Speedometer internals. You will have to find a SW parts catalog, to find the year since most of the early Fords appear identical with minor difference. Ford used speedometers made by three...
Forum: Early V8 (1932-53) 09-05-2020, 06:55 AM
Replies: 3
Views: 269
Posted By Terry,OH
Re: 1936 LB engine fuel pump stand to intake

Ford used the oil baffle tube from 35 till 48. I have never seen a document to insert the tube in any specific direction, for these years, nor is it marked such.
Forum: Early V8 (1932-53) 09-02-2020, 03:29 PM
Replies: 22
Views: 736
Posted By Terry,OH
Re: Headlights

The 39 Ford car did not use sealed beam headlights. Look in the web site for Bob Drake reproductions.
Forum: Early V8 (1932-53) 08-30-2020, 06:01 AM
Replies: 14
Views: 529
Posted By Terry,OH
Re: Radiator Cap

The original cap is not a pressure cap. Adding a pressure cap will eventually bulge the upper brass tank of the radiator.
Forum: Early V8 (1932-53) 08-27-2020, 06:57 AM
Replies: 1
Views: 259
Posted By Terry,OH
Re: '35 Column Drop/Lock/Switch: Lube?

Dry lube such as LPS#1 or a little Graphite.
Forum: Early V8 (1932-53) 08-18-2020, 05:31 PM
Replies: 21
Views: 5,318
Posted By Terry,OH
Re: Vacuum Brake 1932-1948 Ford

In the illustration in post #1 the view of the distributor is from the rear. The arrows of rotation are correct.
Forum: Early V8 (1932-53) 08-18-2020, 04:54 PM
Replies: 10
Views: 438
Posted By Terry,OH
Re: Pressure Plate

The Long style applies more pressure to the clutch plate as RPM increases due to the fly weights, it is a much better pressure plate than the Borg Beck.
Forum: Early V8 (1932-53) 08-16-2020, 05:09 AM
Replies: 8
Views: 473
Posted By Terry,OH
Re: hot ignition switch

Take it apart and clean the contacts. Do not use sandpaper to clean contacts. Also clean the brass threaded terminals on the back of the switch and look at each wire terminal carefully for damage...
Forum: Early V8 (1932-53) 08-13-2020, 05:01 PM
Replies: 13
Views: 1,274
Posted By Terry,OH
Re: Columbia inspection

When you reassemble the clutch make sure to follow instructions included in the kit. since your going to have it apart you should do a complete inspection. Do you know if the Columbia has been...
Forum: Early V8 (1932-53) 08-12-2020, 04:11 PM
Replies: 4
Views: 240
Posted By Terry,OH
Re: Clutch adjust.

make sure any and all the pedal bumpers are in place before adjusting.
Forum: Early V8 (1932-53) 08-11-2020, 05:08 AM
Replies: 4
Views: 307
Posted By Terry,OH
Re: Tranny broken, what parts will fit a 34?

Many of the different years gear sets will fit into the 34 case, (not sure of 50) but you have to get the front bearing in place on the shaft after installing the gear set and the front shaft. The...
Forum: Early V8 (1932-53) 08-04-2020, 06:06 PM
Replies: 10
Views: 403
Posted By Terry,OH
Re: NOS 1938-48 24 Stud Head Gaskets

The 41A gasket is the correct gasket for the 81A engine. You will note the small coolant holes are at the front and the rear coolant holes are larger.
Forum: Early V8 (1932-53) 07-31-2020, 05:49 AM
Replies: 12
Views: 769
Posted By Terry,OH
Re: Carb rebuild instructions

There are several on Ebay. Unless you know what your looking at you can easily get burned there. Many Ebay Carbs are missing parts, incorrect tops, bases, frozen throttle shafts, incorrect parts. ...
Forum: Early V8 (1932-53) 07-30-2020, 06:04 AM
Replies: 15
Views: 564
Posted By Terry,OH
Re: Late 21 stud 85 with 14 mm plugs

Suggest you get a copy of the Early Ford V8 Club of America 1938-39 restoration manual. It can answer many questions. the book is sold on their web site.
Forum: Early V8 (1932-53) 07-30-2020, 06:00 AM
Replies: 8
Views: 407
Posted By Terry,OH
Re: 1935 Sedan Convertible HELP

My best advice is to follow the instruction from Ford. Do you have the manual you found?
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 07:01 AM.