Forum: Early V8 (1932-53)
05-13-2024, 03:37 PM
|
Replies: 8
Views: 428
|
Forum: Early V8 (1932-53)
05-12-2024, 05:17 PM
|
Replies: 224
Views: 100,572
Re: How many of you are working on a 1932 Ford ?
My dad's roadster before he passed away from covid. Now I have it. Ran fine when it was parked. It hasn't been driven in 20-years. When I tried to start it the gas tank was blocked full of goo. I...
|
Forum: Early V8 (1932-53)
05-10-2024, 01:03 PM
|
Replies: 12
Views: 666
Re: pennies
That was a real thing. I live in SoCal and was told by some of old-time dry lake racers that were still around that they preferred to use the WWII 1943 steel pennies in the block, (I'm just telling...
|
Forum: Early V8 (1932-53)
05-09-2024, 01:07 AM
|
Replies: 16
Views: 660
Re: Gas under carbs on manifold
I was going to guess the jets plugs too. It does not look like it has too much fuel pressure and it's overflowing out the top of the carb, it's nice and clean up there. It's something down below,...
|
Forum: Early V8 (1932-53)
05-02-2024, 04:19 PM
|
Replies: 5
Views: 353
Re: Is this a widow maker wheel?
I was a phone company mechanic. We had three-piece rims on 1970s F600 4x4s at work. The Tire shops refused to work on them because they claimed they were "widow makers". So, we changed those tires...
|
Forum: Early V8 (1932-53)
04-19-2024, 02:08 PM
|
Replies: 7
Views: 772
Re: Swap Meet, Redlands, CA
Thanks, I'll be going, it's only 10 miles from here. It's a really small swap meet but I always come home with something I don't need but can't resist.
|
Forum: Early V8 (1932-53)
04-17-2024, 12:46 PM
|
Replies: 20
Views: 1,554
Re: Flat head back firing pop. pop over and over
My dads '32 roadster sat for probably ten-years without being started. It ran fine when he parked it. He finally passed away and I hauled the roaster home. I found a plugged metal fuel line and the...
|
Forum: Early V8 (1932-53)
04-02-2024, 03:54 PM
|
Replies: 10
Views: 716
Re: What is the best head gasket for Alum heads
I have a retired NASA machinist neighbor that built a flathead. Every head stud was leaking because he had run a tap down into each hole. So, them he machined it so each stud had a O-ring under the...
|
Forum: Early V8 (1932-53)
04-02-2024, 03:39 PM
|
Replies: 10
Views: 716
Re: What is the best head gasket for Alum heads
Edelbrock recommends Felpro composite gaskets with their aluminum flathead heads. Because aluminum heads and a cast iron block will expand and contract at different rates you want a gasket that was...
|
Forum: Early V8 (1932-53)
03-04-2024, 10:02 PM
|
Replies: 15
Views: 748
Re: Fuel filter best location
The filter needs to be installed "before" the electric fuel pump to protect the pump. That is what the instructions say on an Airtex fuel pump. The filter and pump both should be located close to the...
|
Forum: Early V8 (1932-53)
03-01-2024, 02:47 PM
|
Replies: 22
Views: 1,382
Re: 1937 distributor quizz question........
I was a mechanic my entire life. When it dies and won't start, I'd pull the air cleaner and see if its squirting fuel into the engine, if it does, it's not a fuel problem. If you want, you could also...
|
Forum: Early V8 (1932-53)
02-12-2024, 11:58 PM
|
Replies: 14
Views: 797
Re: Brake pedal travels too far
I was a fleet mechanic for 30-years. This sounds like one of the problems I would encounter, the first push of the brake pedal moves the shoes outward and a rapid second push of the pedal pins them...
|
Forum: Early V8 (1932-53)
12-23-2023, 09:01 PM
|
Replies: 35
Views: 2,730
Re: Violent shake.
If everything was done right on the clutch replacement, I'd be looking at the motor and trans mounts.
|
Forum: Early V8 (1932-53)
12-23-2023, 08:46 PM
|
Replies: 30
Views: 1,808
Re: adding electric fuel pump
When I was a mechanic Airtex offered a catalog with the specifications for each electric fuel pump, voltage, pressure and if it was "open" or "closed" when it was off. Most of them were closed in the...
|
Forum: Early V8 (1932-53)
07-27-2023, 03:45 PM
|
Replies: 21
Views: 1,023
|
Forum: Late V8 (1954+)
07-26-2023, 01:10 PM
|
Replies: 35
Views: 4,331
|
Forum: Late V8 (1954+)
07-25-2023, 11:21 PM
|
Replies: 35
Views: 4,331
Re: Low compression in one cylinder
I had always heard to use gas instead of water. At the phone company the fire department would not allow us to store any gas cans with fuel in them in the shop. We had overhead lube reels in each...
|
Forum: Late V8 (1954+)
07-25-2023, 10:03 PM
|
Replies: 35
Views: 4,331
Re: Low compression in one cylinder
To be honest with you I don't t know what kind of volume of air a leak down tester puts into a cylinder. It might not be what a compression tester hose with the Schraeder valve removed, and hooked to...
|
Forum: Late V8 (1954+)
07-25-2023, 09:37 PM
|
Replies: 35
Views: 4,331
Re: Low compression in one cylinder
Borderline problems are difficult to diagnose. That was a good idea backing the valves off all of the way. If the exhaust valve was leaking just a little bit, it would be difficult to hear it all the...
|
Forum: Early V8 (1932-53)
07-25-2023, 01:33 PM
|
Replies: 9
Views: 541
Re: 34 ford sedan rear diff whishbones
I straighten that kind of stuff in my hydraulic press, but you can straighten it with a bottle jack and a chain. Hook the chain to each end and put the jack between the chain and the tube and if the...
|
Forum: Late V8 (1954+)
07-24-2023, 06:40 PM
|
Replies: 6
Views: 892
Re: 54 V8 Y Block Spark Plug Wire Running
Years ago, I inherited my mom's 312 '57 T-bird she bought new, it still had the original plug wires. Those were the worst wires I ever had to put on an engine running behind those heads, and I had to...
|
Forum: Early V8 (1932-53)
07-24-2023, 01:47 AM
|
Replies: 19
Views: 1,687
Re: 1936 point gap question
You want to set them to the wide side of the specs because they will wear down. Also you want to use a little point lube on the cam lobe. As they wear and the gap gets smaller it changes the timing....
|
Forum: Late V8 (1954+)
07-24-2023, 12:49 AM
|
Replies: 35
Views: 4,331
Re: Low compression in one cylinder
Running compression test. This would be a test you might do if you have good compression on a static test. It might still be interesting to see what it shows on your low cylinder. This test is rarely...
|
Forum: Late V8 (1954+)
07-23-2023, 07:26 PM
|
Replies: 35
Views: 4,331
Re: Low compression in one cylinder
I take my five-year grandson to taekwondo, and they teach perseverance, winners do not give up, they do not tap out. That's me when working on cars, more like that used to be me. Lately my body doess...
|
Forum: Late V8 (1954+)
07-23-2023, 02:10 PM
|
Replies: 35
Views: 4,331
Re: Low compression in one cylinder
Carbon buildup on moder engines will raise the compression and cause a vehicle to fail a smog test for excessive NOX readings. Excessive pressure and heat combine the oxygen and nitrogen to create a...
|