Forum: Model-A
08-27-2022, 04:59 PM
|
Replies: 0
Views: 438
Southwind gasoline heater
I have a complete and working Southwind Heater used with the Stromberg
carbs. I advertised this unit and got no response. One more try. Call and make an offer. 207 944 3128. Jim.
|
Forum: Late V8 (1954+)
06-20-2022, 09:19 PM
|
Replies: 9
Views: 888
What headers would I use for duals?
Hi folks. I have a 79 302 ford with a 4bbl edelbrock and edelbrock performer
intake. I found that using lighter springs in the distributor and no vac advance gives max power with 32.5 dwell at 3...
|
Forum: Late V8 (1954+)
03-27-2022, 05:21 PM
|
Replies: 19
Views: 1,597
Re: What 5.0L ord engine do I have
The motor has 8500 miles on it. 7200 when i got it. I got the timing fixed. The distributor was not grounding to the block. Cleaned the tie down bolt and holder and that fixed the problem. Found it...
|
Forum: Late V8 (1954+)
01-19-2022, 08:58 PM
|
Replies: 19
Views: 1,597
|
Forum: Late V8 (1954+)
01-15-2022, 09:56 PM
|
Replies: 21
Views: 2,606
|
Forum: Late V8 (1954+)
01-15-2022, 09:55 PM
|
Replies: 21
Views: 2,606
|
Forum: Late V8 (1954+)
01-15-2022, 09:27 PM
|
Replies: 19
Views: 1,597
What 5.0L ord engine do I have
What have I got? This came in my 55 F-100. I have no clue. It has an Edlelbrock 4bbl and manifold and dual exhaust. I'll enclose a picture
of the crate tag. Thank You again for your help.
|
Forum: Late V8 (1954+)
12-01-2021, 09:34 PM
|
Replies: 21
Views: 2,606
Re: 1955 F-100 5.0L timing
84 FMC short block 5.0L. Edelbrock dual plane 4bbl aluminum performer intake with Edelbrock 4bbl carb. New standard ford dizzy.
|
Forum: Late V8 (1954+)
11-30-2021, 08:12 PM
|
Replies: 21
Views: 2,606
1955 F-100 5.0L timing
What is the best method for timing my 5.0L 4v carburetor V8. Do I use the vacuum above or below the throttle plates?
|
Forum: Late V8 (1954+)
11-30-2021, 08:02 PM
|
Replies: 17
Views: 1,855
Re: rusty tank
I have always used Muiratic acid. The new stuff will not burn flesh but will clean rust really well. I use a couple gallons mixed with 20% water. plug the tank and turn every 12 hours until the...
|
Forum: Early V8
07-11-2021, 08:41 PM
|
Replies: 0
Views: 835
Soutwind Hrater complete+ spares
I have a complete and working Southwind heater and many spare parts. Yes it has the carb pickup that is so hard to find. This worked great in my 37 Ford pickup. I even have a correct 12V to 6volt...
|
Forum: Early V8 (1932-53)
06-21-2021, 05:12 PM
|
Replies: 1
Views: 667
1949 Mercury brake drums
Hi folks. Helping a friend find replacement rear brake drums for his 1949 Mercurt 2 door sedan. What all fits? Thank you, Jim.
|
Forum: Late V8 (1954+)
04-16-2021, 04:49 PM
|
Replies: 22
Views: 3,384
|
Forum: Late V8 (1954+)
01-31-2021, 05:55 PM
|
Replies: 22
Views: 3,384
|
Forum: Late V8 (1954+)
01-21-2021, 09:20 PM
|
Replies: 22
Views: 3,384
|
Forum: Model-T
01-21-2021, 09:12 PM
|
Replies: 0
Views: 2,427
Tires and rims for sale
I have 2 never mounted smooth tire no tread design all white tires for sale.
Also I have 2 excellent no lug rims for sale. Sold my T project and am not going to use.Call Jim at 207 944 3128...
|
Forum: Model T (1909-1927)
01-21-2021, 07:53 PM
|
Replies: 11
Views: 3,624
Re: 30x3.5 rims needed
I have 2 UCRL06 as advertised in the link. Very good condition.
Call me at 207 944 3128, Jim
|
Forum: Model T (1909-1927)
01-21-2021, 07:46 PM
|
Replies: 5
Views: 1,765
TT differential to a T defferential
I am wondering if I can replace my TT differential with a regular T differential? I'm not hauling any load but would like more road speed. Any ideas?
|
Forum: Late V8 (1954+)
12-31-2020, 10:56 PM
|
Replies: 12
Views: 2,251
Re: Poorly running fresh rebuilt 292
I had the same problem and it drove me crazy. Turns out i had plugged fuel feeds to the idle jets. No high pressure air will blow it out unless you take the carb off and leaving the jets in but...
|
Forum: Late V8 (1954+)
12-31-2020, 10:41 PM
|
Replies: 31
Views: 4,205
Re: 1955 F100 239 Carb/Dist Upgrade
1957 ford dizzy works very well with edelbrock carbs. Use the diver side vacuum port on the front of the carb. I believe that is direct manifold vac below the butterflies. What a great improvement....
|
Forum: Late V8 (1954+)
12-31-2020, 10:07 PM
|
Replies: 22
Views: 3,384
Re: Help with rims
We machined out the center holes so the wheel fit flat against the hub. and viola. That did it. We opened them about 1/8". I still haven't figured what wheels I need. The pattern is 5x 108mm?
|
Forum: Late V8 (1954+)
12-01-2020, 09:36 PM
|
Replies: 22
Views: 3,384
Help with rims
Okay, I need your expert help again. I now own a nice little 55 ford f-100
that came to me with a newer differential. A 9" ford with 5 on
4 1.25 lug pattern 15 " rims. What the heck is this? I...
|
Forum: Late V8 (1954+)
12-01-2020, 09:26 PM
|
Replies: 23
Views: 6,308
Re: Replacing Teapot carb on 1956 T-bird
I put an Edelbrock performer 4bbl intake and a 4bbl edelbrock 650 carb on my 56 312 ci
y block and didn't change distributor. Very disappointing. Bought and installed a 57 ford dist. and timed up...
|
Forum: Late V8 (1954+)
09-13-2020, 05:55 PM
|
Replies: 11
Views: 1,680
|
Forum: Late V8 (1954+)
09-05-2020, 08:10 PM
|
Replies: 11
Views: 1,680
|