Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.05 seconds.
Search: Posts Made By: jw hash
Forum: Model A (1928-31) 10-24-2020, 08:05 AM
Replies: 15
Views: 718
Posted By jw hash
Re: 1930 Model A Gears Grind After New Clutch Install

I`m going with Edzaha. on the pressure plate adjustment. I replaced a clutch last month. the pressure plate was a rebuilt. I always bolt them up and check for the right finger height, and they were...
Forum: Model A (1928-31) 10-21-2020, 08:30 PM
Replies: 7
Views: 435
Posted By jw hash
Re: Distributor Body Electrodes

the originals dist, body electrodes were steel. and some have lasted 90years,
if it is not broke don`t fix it.
Forum: Model A (1928-31) 10-19-2020, 08:02 PM
Replies: 7
Views: 637
Posted By jw hash
Re: Gas cap mystery

the only gas cap you are showing is #2 number 3 looks like one of the cheap reproduction with the vent hole in the middle of the top. if you fill your tank to full with one of them they will leak....
Forum: Model A (1928-31) 10-18-2020, 07:21 PM
Replies: 4
Views: 235
Posted By jw hash
Re: 31 Slant W/S sedan rear bumpers

on my 160A the stand is 4 3/4" from the top to the center of the rivet. like Bill said you want to make sure you have the correct rear bumper irons. they are longer then most other Model A`s
Forum: Model-A 10-03-2020, 05:51 PM
Replies: 0
Views: 124
Posted By jw hash
NOS slant window locking door handle

here is a original NOS stainless scroll looking handle A400 Victoria 68C or slant window four door, the key number is A1464 i do not have the original key. but i was able unlock it and remove the...
Forum: Model-A 10-03-2020, 05:36 PM
Replies: 0
Views: 154
Posted By jw hash
side bowl carb

here is a good rebuildable side bowl carburetor with original side bowl on it. $130 shipping included lower 48



lowered price
Forum: Model A (1928-31) 10-03-2020, 03:53 AM
Replies: 10
Views: 689
Posted By jw hash
Re: European Classic Tires

I put a set of European classic`s on my 31 160A and have about 300 miles on them. I`m very happy with them.
Forum: Model A (1928-31) 10-02-2020, 09:35 AM
Replies: 10
Views: 340
Posted By jw hash
Re: roof/door trim rail.....perplexed

sounds like he is talking drip rails
Forum: Model A (1928-31) 09-29-2020, 09:22 AM
Replies: 3
Views: 143
Posted By jw hash
Re: Cabriolet 68C Belt Rail Fit Up

the outside of the rail should set about even with the top of radius. I took a couple pictures of my 68B the rail set in the same location on both.
Forum: Model A (1928-31) 09-24-2020, 08:35 AM
Replies: 7
Views: 287
Posted By jw hash
Re: Finishing the Belt Rail on 68C Cabriolet

the belt rail across the back is supposed to be counter bored so the 1/4" 20 screws do not show. i use DP90 on the wood parts, and thin it out so it will soak good.
Forum: Model A (1928-31) 09-21-2020, 09:49 PM
Replies: 30
Views: 1,355
Posted By jw hash
Re: Front Fenders Hit the Shocks?

the shock is upside down. the covers are installed incorrectly. hopefully they put the rest of the shock together correct. if you remove the shock from the car and remove the cover from the shock....
Forum: Model-A 09-20-2020, 06:36 AM
Replies: 1
Views: 247
Posted By jw hash
Forum: Model A (1928-31) 09-19-2020, 08:00 AM
Replies: 30
Views: 1,355
Posted By jw hash
Re: Front Fenders Hit the Shocks?

something tell me the shocks might assembled wrong. and mounted upside down. the bolt pattern is off set.
Forum: Model A (1928-31) 09-16-2020, 07:30 AM
Replies: 3
Views: 299
Posted By jw hash
Re: Eaton cap ID help

yes, it is an Eaton gas cap and it needs a leather gasket. a lot of the venders out there handle them.
Forum: Model A (1928-31) 09-12-2020, 09:18 AM
Replies: 2
Views: 243
Posted By jw hash
Re: Remove windshield/frame Victoria

yes they are the same, the ends of the upper hinge are pinched a little, so sometimes you have to take a screw driver and open it up. it works better with two people to slide it out.
Forum: Model A (1928-31) 09-12-2020, 09:03 AM
Replies: 11
Views: 573
Posted By jw hash
Re: 1/2 Bendix

sent PM
Forum: Model A (1928-31) 09-12-2020, 12:47 AM
Replies: 2
Views: 347
Posted By jw hash
Re: 5 Widow Coupe Rubber Blocks by Quarter Window

there is two of them hard rubber parts. the other one is right forward of that one. I think the only replacements that are out there are made out of wood. you tack the interior panels to them.
Forum: Model A (1928-31) 09-11-2020, 09:00 AM
Replies: 8
Views: 537
Posted By jw hash
Re: Early Model A Right Front Fender required

that is an AR fender he is showing.
Forum: Model A (1928-31) 09-09-2020, 05:54 PM
Replies: 74
Views: 2,539
Posted By jw hash
Re: Title goes with Frame or Engine?

the title should go with the chassis. the title says what the body is on that chassis. here i bought a 31 A with a 29 motor in it. years ago in this state if you change the motor you would go to the...
Forum: Model A (1928-31) 09-06-2020, 06:11 PM
Replies: 1
Views: 139
Posted By jw hash
Re: Rear shackel/shock link ball to backing plate clearance

pluck a lot of times, a chassis without a body on it they are touching. same with the front if there is no engine in the chassis. when you put a lot on it and the shackles swing into place. it should...
Forum: Model A (1928-31) 09-06-2020, 06:05 PM
Replies: 12
Views: 488
Posted By jw hash
Re: Vicky bracket ?????

I have worked on a lot of Victoria`s and I do not remember ever seeing those brackets. I know some 4 door bodies had some similar brackets in the top.
Forum: Model A (1928-31) 09-04-2020, 08:33 PM
Replies: 44
Views: 2,361
Posted By jw hash
Re: Garage lights

i switched over to LED in my house,garage, and shop including the paint booth. it is nice to turn on the lights and all of them come at the same time. and they don`t hum like the fluorescent`s.
Forum: Model A (1928-31) 09-02-2020, 09:53 PM
Replies: 1
Views: 172
Posted By jw hash
Re: Cabriolet 68C Top of Body Wood Rails

they are 1/4 20 stove bolts. or called slotted round head screws. the rail is counter bored and the screw end up below the top of the rail. I`m not sure on how the lower landau bracket fastens it...
Forum: Model A (1928-31) 09-01-2020, 02:05 PM
Replies: 5
Views: 365
Posted By jw hash
Re: 28 and 30 rear end differences

the brake system is different. finding an AR good ring & pinion is not that easy. they are completely different. using your braking plates, drums and radius rods you can install a 30 rear end.
Forum: Model A (1928-31) 08-28-2020, 08:22 PM
Replies: 18
Views: 1,096
Posted By jw hash
Re: Model A Taxi

Steve Hamilton`s was an original ford production one, and it went to Australia. I remove all the asbestos containing materials from the car and replaced it with non asbestos containing materials in ...
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 04:09 PM.