Forum: Model A (1928-31)
08-28-2023, 10:11 PM
|
Replies: 34
Views: 3,413
Re: Won't run
It could also be a coil failing as they tend to give the same pattern when they start to fail.
|
Forum: Model A (1928-31)
04-26-2023, 11:14 AM
|
Replies: 7
Views: 1,224
Re: Canada Bought or Built
Other differences between the American and Canadian cars were in the bumper clamps (at least for the 30-31s). The American cars had bumper clamps with recessed painted inserts and no appearance of...
|
Forum: Model A (1928-31)
03-31-2021, 12:52 PM
|
Replies: 67
Views: 10,853
|
Forum: Model A (1928-31)
05-27-2020, 11:41 PM
|
Replies: 6
Views: 2,987
Re: Lincoln Bomb sight wheel balancer
The only literature I could find on Lincoln bomb sight balancer was the following http://www.lincolnindustrial.com/history/files/WheelBalancer.pdf. (but it looks like it's mentioning model 7571)
|
Forum: Model A (1928-31)
05-20-2020, 12:58 PM
|
Replies: 13
Views: 1,923
|
Forum: Model A (1928-31)
05-19-2020, 11:32 PM
|
Replies: 13
Views: 1,923
Re: Station wagon rear fenders
Hard to see but it's ripped right across the lower section, dented and creased inwards about halfway up as well. The body shop I'm taking it to hasn't seen it yet so possibly they'll say whether or...
|
Forum: Model A (1928-31)
05-19-2020, 11:30 PM
|
Replies: 13
Views: 1,923
|
Forum: Model A (1928-31)
05-19-2020, 10:44 AM
|
Replies: 13
Views: 1,923
Re: Station wagon rear fenders
Thanks Brent! Hoping to save mine but, if it's not replaceable , at least I know exactly what to look for with your information.
|
Forum: Model A (1928-31)
05-19-2020, 08:54 AM
|
Replies: 13
Views: 1,923
Station wagon rear fenders
Anyone know which body styles share the same rear fender as a 1931 Station wagon? I may need to get a replacement for the passenger side rear so if anyone has any for sale, that would also be...
|
Forum: Model A (1928-31)
12-27-2019, 10:39 PM
|
Replies: 44
Views: 7,190
Re: Generator vs Alternator
They also have the LED replacement bulbs that fit in the original sockets. If you're not concerned about the authenticity of the bulb and want bright beams with low amperage draw, then that could...
|
Forum: Model A (1928-31)
10-26-2019, 08:13 PM
|
Replies: 7
Views: 1,591
Re: Pan Gasket Install
And careful on the torque specs listed in the Les Andrews book if you're going by those for the pan. Someone in our club mentioned it's got a missprint of 20 ft/lbs when it should be something like...
|
Forum: Model A (1928-31)
06-04-2019, 08:38 PM
|
Replies: 21
Views: 5,304
Re: So what is an AR?
Did Henry designate the early 28's as AR because of his earlier model A in the early 1900's?
|
Forum: Model A (1928-31)
06-04-2019, 08:30 PM
|
Replies: 15
Views: 2,004
Re: Starts then stops
The last time I experienced a similar issue was the condensor went bad. It would start for a few seconds then die right away.
|
Forum: Model A (1928-31)
06-03-2019, 10:47 AM
|
Replies: 18
Views: 3,354
Re: 31 coupe will not go over 40 mph
Check the condition of your spark plugs as well. If any are wet or showing signs of poor performance, they could also be a cause of unburnt fuel going out to the exhaust and running on less than 4...
|
Forum: Model A (1928-31)
04-11-2019, 05:07 PM
|
Replies: 116
Views: 22,184
Re: Sudden rough running, out of ideas
When you check the distributor cap carbon point, don't forget to check the gap on the rotor itself and make sure there's no slop in the distributor shaft. If those are set to wrong gap or the shaft...
|
Forum: Model A (1928-31)
03-25-2019, 11:26 AM
|
Replies: 29
Views: 8,915
Re: Le Baron Bonney, Out of Business?
Would be nice to see someone pick up the company but as Brent mentions, you need the skillset, the equipment, etc. It may also be the volume of orders required to keep the business feasible from a...
|
Forum: Model A (1928-31)
03-11-2019, 11:35 AM
|
Replies: 25
Views: 4,324
Re: 29 Tudor hood alignment
Just a guess, but would you happen to have too much rubber (or other insulator) under the rad supports at the front. It looks like the rad might be sitting a little too high in comparison to the cowl...
|
Forum: Model A (1928-31)
12-13-2018, 12:40 PM
|
Replies: 89
Views: 15,920
|
Forum: Model A (1928-31)
11-02-2018, 08:41 PM
|
Replies: 6
Views: 2,017
Re: body roll and wallowing
Another site mentioned if the car leans to one side the steering geometry changes so you have to constantly correct or over correct on your steering and the cars wanders around the road. They...
|
Forum: Model A (1928-31)
11-02-2018, 11:55 AM
|
Replies: 90
Views: 16,763
Re: Terriable backfiring
If the head is straight and not the issue with the compression loss, would a poor valve seat, bent valve or sticking valve let air from #3 to #4 and vice versa?
|
Forum: Model A (1928-31)
10-26-2018, 07:50 PM
|
Replies: 11
Views: 2,071
Re: Proper Head Installation
With the continuous heating and cooling of the block, you can get bolts loosening over time. I've been told to retorque the head a few times if the head is re-installed and then it won't hurt to...
|
Forum: Model A (1928-31)
10-21-2018, 07:52 PM
|
Replies: 10
Views: 1,793
Re: 4 blade fan woble
Just be warned, if it wobbles too much it could stress or fatigue the blades. Make sure your fan is still in good condition and running in a balanced fashion. I had one of those four blades on my car...
|
Forum: Model A (1928-31)
10-21-2018, 07:49 PM
|
Replies: 19
Views: 3,310
Re: Here is a bargain! LOL
Nice original condition bug but I doubt anyone will be willing to cover that amount. It does draw in the viewers to the ad though.
|
Forum: Model A (1928-31)
10-13-2018, 07:57 PM
|
Replies: 20
Views: 5,281
Re: AA hearse
Early motorhome? When you get tired of driving you can just hop in the back for a rest....
|
Forum: Model A (1928-31)
10-13-2018, 07:52 PM
|
Replies: 90
Views: 16,763
Re: Terriable backfiring
Similar to what Curtis has mentioned, I've run into fuel blockages due to rust (either in tank or sediment bowl) and with movement of the vehicle it can stir up the sediment and block the fuel flow....
|