Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: Rowdy
Forum: Early V8 (1932-53) 09-30-2014, 07:07 PM
Replies: 13
Views: 2,785
Posted By Rowdy
Re: Open drive to closed drive trans conversion

Aiming for slightly postwar at the newest. Likely will sell my 37 21 stud and opt for the 59A instead. It was my original intention to use the 21 stud just to be alittle different, but think that...
Forum: Early V8 (1932-53) 09-30-2014, 06:21 PM
Replies: 13
Views: 2,785
Posted By Rowdy
Re: Open drive to closed drive trans conversion

If I do not find a set over the winter locally I will let you know. There are 3 sets locally, but they are all still under what is left of the cars. Was on "Junk Jaunt" and at Freemont swapmeet this...
Forum: Early V8 (1932-53) 09-30-2014, 05:26 PM
Replies: 13
Views: 2,785
Posted By Rowdy
Re: Open drive to closed drive trans conversion

Sounds like we are on the same budget. I have the 47 pu center crossmemeber from the one I parted out, other than that I would have looked for something else also. So far I have about $470 into the...
Forum: Early V8 (1932-53) 09-30-2014, 04:55 PM
Replies: 13
Views: 2,785
Posted By Rowdy
Re: Open drive to closed drive trans conversion

I am gathering parts for the same, but am using a 42-47 pu rearend center section, so I can have an open drive shaft. I have not located a set of 35-36 axle hsgs yet to complete modified narrowed...
Forum: Early V8 (1932-53) 09-30-2014, 02:49 PM
Replies: 13
Views: 2,785
Posted By Rowdy
Re: Open drive to closed drive trans conversion

Same transmission as the 39. Just need to swap the output shaft and the rear bearing retainer. I am sure some one here ot on the HAMB would gladly swap. If I did not already have the parts for the...
Showing results 1 to 5 of 5

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 07:14 AM.