Forum: Model A (1928-31)
04-12-2024, 08:21 AM
|
Replies: 30
Views: 1,834
Re: Removing Lug Nut from Spinning Stud
So it looks like you were able to save the wheel. I'd be more worried that the hub was still flat than having a gouge especially after all of the work to get the wheel off. How deep is that mark? If...
|
Forum: Model A (1928-31)
01-23-2024, 06:11 PM
|
Replies: 31
Views: 2,022
Re: Do rivet nuts work?
I used rivet nuts to install my handmade metal floor pan beneath my roadster. works perfectly and I've had it in and out multiple times with no issue. I've been dealing with rivnuts for a long time...
|
Forum: Model A (1928-31)
10-14-2023, 08:39 PM
|
Replies: 12
Views: 1,154
Re: Light switch yardstick trick
Gaffers Tape also doesn't leave adhesive like duct tape does;comes up easily. Rips easily like duct tape, but its also more expensive. It's typically used to tie down wires to the floor or stage.
|
Forum: Model A (1928-31)
08-10-2023, 08:21 PM
|
Replies: 4
Views: 491
Re: Hood retainer, cage, problem
I had similar problems with my roadsters dash rail. I just drilled it out and tapped. If you're afraid you could probably use jb weld and tap the larger hole back to the smaller size. I wouldn't say...
|
Forum: Model A (1928-31)
08-01-2023, 10:54 PM
|
Replies: 20
Views: 1,611
Re: Carburetor leaking
If this is the case they can be repaired. I have soldered 2 and both have and still do work fine.
|
Forum: Model A (1928-31)
05-31-2023, 05:39 PM
|
Replies: 43
Views: 4,485
Re: Metal Stitching my Block
If you ever happen across a copy of the Victor Page Model A Restorer book I recall a section that discusses engine crack repair. Some distinctly antiquated repair methods were given. I'm not saying...
|
Forum: Model A (1928-31)
05-22-2023, 09:07 PM
|
Replies: 29
Views: 3,092
Re: Dang, Grease on the Headliner
Brake clean works wonders but may damage the fabric, I'd start with something similar to Simple Green or Purple Power however, since It's a light color fabric I'd try to find a generic degreaser...
|
Forum: Model A (1928-31)
05-12-2023, 08:24 AM
|
Replies: 41
Views: 5,090
Re: The Bounce
I would look at the springs,maybe something is cracked. Can you seen any evidence of frame repairs? If one side was repaired it could be stiffer than the other. Not that I've ever heard of this maybe...
|
Forum: Model A (1928-31)
03-21-2023, 11:38 PM
|
Replies: 5
Views: 774
|
Forum: Model A (1928-31)
01-31-2023, 09:30 PM
|
Replies: 5
Views: 1,020
Roadster v Coupe Body Work
I'm finishing up some body work on my 30 Roadsters quarter panels and finalizing the various radii on the front sections of the rear panels. Am I ok to assume that the radii of a coupe and roadster...
|
Forum: Model A (1928-31)
12-19-2022, 06:19 PM
|
Replies: 5
Views: 1,065
Re: Hydrolic Brakes
Have you ever bled the brakes out and changed the fluid? DOT brake fluid can crystallize and cause lockup,water intrusion will ruin fluid quickly. Has happened to me on a motorcycle before. Rust is...
|
Forum: Model A (1928-31)
11-23-2022, 06:23 PM
|
Replies: 11
Views: 1,936
Re: Rumble Lid Outer Skin Replacement
I just finished up doing the same, built one lid from two. Took way longer than I was hoping since I was trying not to destroy or distort either piece.
|
Forum: Model A (1928-31)
11-03-2022, 08:55 PM
|
Replies: 9
Views: 1,938
Re: Rumble lid vs Trunk Fitment issues.
I understand fitment is critical, I'm constantly placing the lid on and then removing. Much easier to do it right the first time than to have to redo it. There are plenty of parts of my project That...
|
Forum: Model A (1928-31)
11-02-2022, 11:04 PM
|
Replies: 9
Views: 1,938
Re: Rumble lid vs Trunk Fitment issues.
Thanks everyone, I was able to make the two halves fit together with some dolly work and some trimming. There's still primer work to do; I'm still inching forward .
|
Forum: Model A (1928-31)
10-24-2022, 05:06 PM
|
Replies: 9
Views: 1,938
Rumble lid vs Trunk Fitment issues.
I already know pictures would have helped with this. But didn't cross my mind at the time.
I recently purchased a rumble lid off a restored car, Looked good,gent I bought it from told me his story...
|
Forum: Model A (1928-31)
09-05-2022, 09:33 PM
|
Replies: 15
Views: 2,458
|
Forum: Model A (1928-31)
08-25-2022, 01:39 PM
|
Replies: 6
Views: 1,327
|
Forum: Model A (1928-31)
08-16-2022, 10:19 PM
|
Replies: 50
Views: 11,446
Re: New Focused-Beam LED Headlights
Purchased a set. The visibility is incredible. Still looks wrong to me, but I can't see them while I'm driving anyway. Mine flicker,previous LED's did too. I'll figure that out.
|
Forum: Model A (1928-31)
07-29-2022, 09:28 PM
|
Replies: 34
Views: 5,292
Re: How to Get Title to Grandpa’s A
In NYS before before 1973 I believe there were no vehicle titles, registrations were transferable. So signing a transferable registration is all that was needed. Of course I can't say what the story...
|
Forum: Model A (1928-31)
07-21-2022, 09:55 PM
|
Replies: 29
Views: 4,539
Re: body paint
Prep is always the key to a good paint job. Before I paint or prime a panel I always wipe with acetone, then wax and grease remover. I fear though that this will ruin your remaining "original" paint...
|
Forum: Model A (1928-31)
07-14-2022, 10:56 PM
|
Replies: 16
Views: 2,311
Re: Very slow air leak in tire
Tubes in cars are the same as tubes in a bicycle, albeit typically thicker. There's nothing special here though. One thing you should know is that Co2,is actually soluble in butyl rubber. This means...
|
Forum: Model A (1928-31)
06-27-2022, 11:30 AM
|
Replies: 22
Views: 3,568
Re: Poll: Showing or Driving or Both
I think I like rebuilding them most,that's not an option but that's my choice. Driving them would be my second choice. I do use the RPU as a truck,it gets plenty of attention when loaded up.
|
Forum: Model A (1928-31)
06-07-2022, 09:22 PM
|
Replies: 3
Views: 1,405
Re: Water stains-help!
Can you post or message a picture? I do a fair bit of interior detailing, there might be an easy solution.
|
Forum: Model A (1928-31)
06-06-2022, 09:55 PM
|
Replies: 64
Views: 8,207
Re: WD40 as hand cleaner
I believe it's called "defatting" basically it pulls the oils out of your skin. Not Ideal. I have a friend that exclusively uses brake cleaner to clean his hands. He's not a patient man.
I try to...
|
Forum: Model A (1928-31)
06-03-2022, 11:21 PM
|
Replies: 7
Views: 1,294
Runs poor after leaving Fuel on
I'm a little confused, occasionally when I mistakenly leave the fuelcock in the on position when running into a store or similar short trip my 30 RPU won't run properly- Bucking and hesitating. I...
|