Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 2 of 2
Search took 0.00 seconds. Search: Posts Made By: flatrod
Forum: Early V8 (1932-53) 01-11-2016, 04:48 PM
Replies: 44
Views: 14,951
Posted By flatrod
Re: Blower motor center main cap

I tighten studs in by hand. If its a take-a-part engine, then I usually lock tight them in. If you try to torque them in to a hole that is open, then you are forcing the shank of the stud into the...
Forum: Early V8 (1932-53) 01-10-2016, 06:39 PM
Replies: 44
Views: 14,951
Posted By flatrod
Re: Blower motor center main cap

Bill, the side rails were not drilled and taped. I did that when I made the pan. It uses the original pan bolts are used to hold the sides down, but were brought up to 3/8 in the block. Then the...
Showing results 1 to 2 of 2

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 03:09 AM.