Forum: Model A (1928-31)
06-09-2016, 11:21 PM
|
Replies: 6
Views: 1,604
Occasional Starter Noise
Occasionally I press the starter and just get a "whrrring" noise. I take my foot off and press again and starts fine. This does not always happen ....maybe 1 in 10 starts, Any thoughts?
|
Forum: Model A (1928-31)
10-25-2015, 06:59 PM
|
Replies: 6
Views: 1,480
Leaking Oil while engine runs
Hopefully this photo is attached. I have oil leaking from a small hole in flywheel housing(?). It leaks when running but stopped when engine turned off. This car (30 pickup) has a later ('39)...
|
Forum: Model A (1928-31)
09-16-2015, 09:43 PM
|
Replies: 13
Views: 1,983
Re: No oil pressure
to be honest, I never paid much attention to the gauge before I happened to notice this time
|
Forum: Model A (1928-31)
09-16-2015, 09:42 PM
|
Replies: 13
Views: 1,983
Re: No oil pressure
If I remove the gauge how do you know if there is oil pressure? or am I worrying for no reason, seemed to run normal.
|
Forum: Model A (1928-31)
09-16-2015, 09:26 PM
|
Replies: 13
Views: 1,983
|
Forum: Model A (1928-31)
09-16-2015, 08:03 PM
|
Replies: 13
Views: 1,983
No oil pressure
Started 30 pickup after a few months and noticed oil pressure gauge at zero, was running okay but I turned it off. Problem?
|
Forum: Model A (1928-31)
05-30-2013, 05:54 AM
|
Replies: 6
Views: 2,675
|
Forum: Model A (1928-31)
05-29-2013, 11:12 PM
|
Replies: 6
Views: 2,675
|
Forum: Model A (1928-31)
01-09-2013, 09:13 PM
|
Replies: 26
Views: 10,816
Re: Lean-to-the-left....
Should vehicle be on jack stands while this is done? Or, can it stay on its tires. If jacked, where should jack stands be located?
Thanks.
John
|
Forum: Model A (1928-31)
09-15-2012, 10:47 PM
|
Replies: 16
Views: 4,471
AA engine
Looking in various publications I have seen AA trucks pulling heavy loads. What was the engine in the AA? A heavier duty 4 cylinder?
|
Forum: Model A (1928-31)
12-21-2011, 09:59 PM
|
Replies: 21
Views: 5,468
|
Forum: Model A (1928-31)
12-20-2011, 02:14 PM
|
Replies: 21
Views: 5,468
Garage Heating and AC
Has anyone built a heated/cooled garage for your Model A lately? If so, what heating and air conditioning system did you use? Any concern with potential gas fumes from the car and the fuel source for...
|
Forum: Model A (1928-31)
11-27-2011, 04:57 PM
|
Replies: 5
Views: 1,760
|
Forum: Model A (1928-31)
11-27-2011, 04:14 PM
|
Replies: 5
Views: 1,760
Stains from exhaust pipe
When I start my 30 pickup, there are black spots on the driveway , a discharge from the exhaust pipe. It is a mostly dry substance, with no smell, looks like soot from a fireplace. Any thoughts?
...
|
Forum: Model A (1928-31)
11-05-2011, 09:40 PM
|
Replies: 6
Views: 1,743
|
Forum: Model A (1928-31)
11-05-2011, 04:10 PM
|
Replies: 6
Views: 1,743
|
Forum: Model A (1928-31)
11-05-2011, 03:32 PM
|
Replies: 6
Views: 1,743
changed antifreeze and have a question
I recently drained the coolant from my radiator and added new water and antifreeze, as I am a new owner and did not know how old it was. I drained about 2 1/2 gallons, and added three per my...
|
Forum: Model A (1928-31)
10-23-2011, 07:28 PM
|
Replies: 4
Views: 2,537
Gas Ration Sticker Location
What is correct placement for WWII gas ration sticker. I have seen one Model A with the sticker on lower corner of passenger side of windshield. Is this correct location?
|
Forum: Model A (1928-31)
10-18-2011, 08:38 PM
|
Replies: 7
Views: 1,974
Uphill Driving
I have a very steep, long driveway. Any tips for getting more power? Car is in first gear, but goes very slow.
|
Forum: Model A (1928-31)
10-18-2011, 08:31 PM
|
Replies: 20
Views: 4,762
|
Forum: Model A (1928-31)
10-10-2011, 07:23 PM
|
Replies: 1
Views: 1,444
39 ford transmission in Model A?
I saw a reference in a thread to a 39 ford transmission in a Model A. When I had mine in(recently purchased) recently for some repairs, I was told that it has a 39 transmission. Was this a common...
|
Forum: Model A (1928-31)
09-03-2011, 05:54 PM
|
Replies: 1
Views: 1,105
slash pan too wide?
Installing splash pans, the holes closest to radiator line up with frame and oil pan, but rear holes are about an inch too wide. Is this common....do you have to bend to fit?
|
Forum: Model A (1928-31)
08-28-2011, 07:04 AM
|
Replies: 13
Views: 2,449
|
Forum: Model A (1928-31)
08-21-2011, 05:50 PM
|
Replies: 13
Views: 2,449
|
Forum: Model A (1928-31)
08-10-2011, 05:20 PM
|
Replies: 15
Views: 2,636
|