Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 7 of 7
Search took 0.00 seconds. Search: Posts Made By: likemlow
Forum: Late V8 (1954+) 04-10-2020, 11:24 PM
Replies: 15
Views: 2,245
Posted By likemlow
Re: Where were the Wagons Built?

I just remembered there was also a Ford plant in Pico Rivera, CA (L.A. area )
in the early 60's. Could that be the one you remembered ?
Forum: Late V8 (1954+) 04-10-2020, 11:07 PM
Replies: 15
Views: 2,245
Posted By likemlow
Re: Where were the Wagons Built?

My 56 Ranch Wagon was built in the Long Beach CA plant.
Forum: Late V8 03-31-2013, 10:22 PM
Replies: 5
Views: 2,625
Posted By likemlow
Re: 15 x 5.5 Steel wheel 5 on 5.5 bolt pattern

if you still have the wheel I'll take it. send me a pm. thanks
Forum: Late V8 06-26-2011, 01:01 AM
Replies: 1
Views: 1,133
Posted By likemlow
Re: 64 F250 parting out

would you happen to have a y-block flywheel for the 10'' clutch ? thanks
Forum: Late V8 (1954+) 04-19-2011, 10:32 PM
Replies: 1
Views: 1,489
Posted By likemlow
Re: Y Block 3x2 Strombergs

nice looking setup, where did you get the stacks or did you make them? are they stainless?
Forum: Early V8 02-11-2011, 02:25 AM
Replies: 3
Views: 1,149
Posted By likemlow
Re: Wanted: '35 Hydrostatic Gas Sender

I have a nice used one out of a car. It was working well when I removed it.
Forum: Late V8 (1954+) 10-11-2010, 11:14 AM
Replies: 2
Views: 1,288
Posted By likemlow
Re: 56 ford car o-drive trans

I have one on the bench.
total length from end of the input shaft to the end of the output is 34"
length of the casing alone is 27 1/4"
length from the center of the crossmember mounting point to...
Showing results 1 to 7 of 7

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 12:49 PM.